I have a 1991 Honda Accord EX. It's 16 valve and it's a 4 cylinder. I have seen this procedure done but it's been a long time. Can someone give me either a diagram or directions on how to replace the valve cover gasket. Also should I replace the sparks plugs as well? Thank you very much!!!Anyone have a diagram on how to change a valve cover gasket....??
Valve cover gasket is an easy task... simply disconnect anything mounted to the top... unbolt it (outside diameter of cover) and pull it off (be careful as not to bend the lip). Replace the gasket (make sure both mating sides are clean)... and reinstall the bolt starting in the middle on each side, working your way around. DO NOT OVER TIGHTEN the bolts... that is a common mistake. Reconnect anything you pulled off... and test it out.
Replacing spark plug is never a bad idea... especially if they have many miles on them.
- Good Luck!Anyone have a diagram on how to change a valve cover gasket....??
Remember that the cover is just thin metal, with only the rubber gasket underneath it, so tighten gently or you will bend it. It will leak from then on...The manual should have the torque--it will be small, probably in in. lbs., 12 in. lbs. makes 1 ft. lb.
Best regards,
Mike
